Sand Loop Level 245 Solution

Step 1: Position the main rotating platform to effectively catch falling sand and prevent initial spillage.

Drag the red slider at the top-left to rotate the large gray platform to a steep, almost vertical angle (approximately 80-85 degrees from horizontal). This creates a deep funnel-like structure.

Sand falls from the dispenser onto the main platform and starts accumulating and flowing downwards along its surface without immediately spilling off the sides.

Step 2: Adjust the platform angle to guide the accumulated sand precisely onto the small, stationary lower platform.

Gently move the red slider slightly to the left (decreasing the platform's angle by a few degrees) to create a consistent flow path for the sand towards the right, onto the small, fixed platform. The goal is to establish a steady stream.

Sand flows smoothly and continuously from the large platform onto the smaller, lower platform, and then progresses into the funnel below.

Step 3: Allow sufficient sand to flow into the target container to reach 100% fill.

Maintain the platform's adjusted angle from Step 2 without further manipulation. Observe as the sand continues to pour through the funnel into the target container until it is full.

The 'Level Completed!' message appears on screen, confirming the target container is 100% filled.

Q: How do I control the flow of sand in this level?

A: You control the sand flow by dragging the red slider located at the top-left of the screen, which adjusts the angle of the large gray rotating platform. Manipulate its tilt to guide the sand.

Q: Why is sand spilling off the side of the platform and not reaching the target?

A: This common issue occurs if the large rotating platform is not angled steeply enough. Try setting it to a more vertical position (closer to 90 degrees) to create a deeper channel that will contain the sand and funnel it effectively towards the lower platform.